Need A New Muffler Clamp!

Removed my rear wheel. Did so by loosening the muffler. Found the rear clamp was rusted up bad! Broke in pieces. The front one if OK. I measured the exhaust pipe as 5 !/2" around. This calculated the diameter to be 1.59". This seems too small. Anyone replaced one of these clamps with an aftermarket clamp? I see lots on Amazon, very reasonable compared to the Honda clamp for $25+. Looking for information.

Thanks,

LeeU
Casa Grande, AZ

You can probably find a U-clamp at any auto parts store that will fit but it will look ugly. Finding a clamp made from flat strap similar to the OE (not round) is a different matter. :-(