Mounting Garmin GPS

Mikethebike · Feb 25, 2018

I'm going to mount the GPS on my wife's NT using the standard RAM Mounts.
I want to screw a ball joint into the plugged rear view mirror hole on the clutch perch.
Can anyone tell me what the thread size is. I can't check as the bike is in the UK and I'm in Washington State.
Thanks in advance
Michael

Sojourner · Feb 25, 2018

It should be M10 x 1.25, but wait for confirmation from someone else here. I ordered one of these, but haven't installed it yet. I just went out to pry out the plug in the clutch lever, but it's in there good, and I don't want to destroy it just yet.

https://www.amazon.com/gp/product/B0036G97DG/

Mikethebike · Feb 25, 2018

If its 10mm its probably 1.25
Thanks
lets see what comes up.
M

RedLdr1 · Feb 25, 2018

Do a "Search" on 10MM and several threads will come up confirming that size for the clutch lever...

Woodaddict · Feb 25, 2018

correct 10mm x 1.25, that would be the course type of thread

ARKNT · Feb 25, 2018

I don't have a thread gauge to properly measure but using a measuring rule and old bad eyes it looks to be 10mm x 1.25.

Brad

DirtFlier · Feb 26, 2018

Yes, 10 mm x 1.25 is the standard thread size for Honda mirror stems. If you go to the RAM website, you can easily find them available.

Rand soper · Feb 26, 2018

When I mounted mine I went to ACE Hardware down the street and found a nice pan head mounting bolt that takes a 5mm hex for about $1.00. Works perfectly

Mikethebike · Feb 26, 2018

Thanks all,
Got one on order already
Michael