Question about foam rubber strip inside Middle Cowl

skiper

Guest
This 7 inch long x 1/2 inch strip of foam rubber dropped out of my right side middle cowl when I had it off today. The shop manual shows something over a foot long in there. I'm guessing it came from the empty space between the cowl pocket and outer panel. I've got to glue it back in but not sure what it does and * where to place it . Does anyone know ? Is it to add stiffness or stop airflow ? Manual picture page 3-13 bottom pic -- I've got two thirds that line, so should it be glued on which part of that line ?
 
Mine were lost a long time ago with no noticeable detriment. But then again I have a couple of screws left over from various bike jobs and they probably are important.
 
Had same problem with mine when adding a farkle after 4 days of ownership. Took out left and right fairing pockets, both where starting to come off. Its about 7" -8", not the 12". A very flimsy way to glue on,looked like thin, not very sticky,double sided tape. Mine was only part way off, so I glued it better. For me, it was attached on the pocket outside, I did see a line there, but don't remember if its above or below, but somewhere around there. Seems to me it keeps both rain and air/dust out. Goes around the side, then curves to front area.
 
THANKS GUYS , I'll figure out what to do a little easier
 
You must log in or register to reply here.
Back
Top Bottom