Mounting Garmin GPS

[Mikethebike]

I'm going to mount the GPS on my wife's NT using the standard RAM Mounts.
I want to screw a ball joint into the plugged rear view mirror hole on the clutch perch.
Can anyone tell me what the thread size is. I can't check as the bike is in the UK and I'm in Washington State.
Thanks in advance
Michael

 

[Sojourner]

It should be M10 x 1.25, but wait for confirmation from someone else here. I ordered one of these, but haven't installed it yet. I just went out to pry out the plug in the clutch lever, but it's in there good, and I don't want to destroy it just yet.

https://www.amazon.com/gp/product/B0036G97DG/

 

[Mikethebike]

If its 10mm its probably 1.25
Thanks
lets see what comes up.
M

 

[RedLdr1]

Do a "Search" on 10MM and several threads will come up confirming that size for the clutch lever...

 

[Woodaddict]

correct 10mm x 1.25, that would be the course type of thread

 

[ARKNT]

I don't have a thread gauge to properly measure but using a measuring rule and old bad eyes it looks to be 10mm x 1.25.

Brad

 

[DirtFlier]

Yes, 10 mm x 1.25 is the standard thread size for Honda mirror stems. If you go to the RAM website, you can easily find them available.

 

[Rand soper]

When I mounted mine I went to ACE Hardware down the street and found a nice pan head mounting bolt that takes a 5mm hex for about $1.00. Works perfectly

 

[Mikethebike]

Thanks all,
Got one on order already
Michael