Hello fellow bikers! I don't know if I am alone in this or not... but I rarely use my engine kill switch. I simply turn the ignition key on or off as needed. This morning I used the kill switch to kill the engine for the first time in quite awhile. (Maybe a year?) When I switched it back to the run position and tried starting the engine - nothing. Like the kill switch was still engaged. Flipped it on and off a few times. Still nothing. After 10 times or so, the engine started like normal.
Is this simply a matter of the contacts in the switch being dirty from non use you think? Has anyone replaced their kill switch? Thoughts? Suggestions?
This is on my 2010 NT700V
Is this simply a matter of the contacts in the switch being dirty from non use you think? Has anyone replaced their kill switch? Thoughts? Suggestions?
This is on my 2010 NT700V