Rostra Cruise Control from Murphskits.com

[Rusty_Iron]

Rusty_Iron, would you have taken a pic of this? Is there any interference/binding between the two cables in the same pulley?

Groove to allow installation of cable


Cable in place pictures


The cables don't seem to rub against each other as they pull together. I'm interested in what responses the group has regarding this type of installation.

 

[Miairhead]

When I had my BMW CLC I used the cruise many times when I was below 50 in areas where the speed limit was lower and the traffic was light. When I was in very hilly areas with lots of curves, I almost never had the cruise on. Cruise is nice on long roads out in the west, but little value I found for me in the roads I like to ride.

 

[Phil Tarman]

My throttle body shaft has a nut that secures the pulley, not a bolt. I doubt that my 2010 is different than yours.

I'm sure your '10 is just like mine. Imagine this. We used a longer nut and then screwed a threaded rod into that and used that to assemble the fender washers on. I'll try to get a (very) crude drawing done and send a picture of that. It may take a day or two.